Opt 81 fiji sync issue

[phones1]

Hi

Today a power supply (CE) went in one of my network shelfs (net grp1 Sh1) whch caused a sys load & since then I have 3 fiji cards that wont sync with the switch :-( . Any ideas on how to bring them back in??????

.stat ring 0
RING STATE: SURVIVAL STATE
RING AUTO RECOVERY IS ON
FIJI 0 0 ENBL <---- Shows as enl here but card has "LOS & Act" leds on
FIJI 1 0 SYS DSBL - NOT RESPONDING
FIJI 2 0 UNEQ
FIJI 3 0 UNEQ
FIJI 4 0 UNEQ
FIJI 5 0 UNEQ
FIJI 6 0 UNEQ
FIJI 7 0 UNEQ

.stat ring 1
RING STATE: SURVIVAL STATE
RING AUTO RECOVERY IS ON
FIJI 0 1 ENBL
FIJI 1 1 SYS DSBL - NOT RESPONDING
FIJI 2 1 UNEQ
FIJI 3 1 UNEQ
FIJI 4 1 UNEQ
FIJI 5 1 UNEQ
FIJI 6 1 UNEQ
FIJI 7 1 UNEQ


Cheers


Remember if it doesn't work hit it harder

Scott UK

 

[KCFLHRC]

I think I would faceplate disable them, pull them out, plug them back in and then see how they act. Run the TEST 360 afterwards

 

[phones1]

wheres test 360?


Thanks

Remember if it doesn't work hit it harder

Scott UK

 

[KCFLHRC]

All of the FIJI commands are in LD 39

 

[KCFLHRC]

Any luck??