schell1535
Programmer
I have automated sending an Outlook 2000 email from an Access 2000 application. Everything was working fine. The code is simple and very close to the sample code provided by Microsoft.
Recently the office upgraded to Exchange 2000. Now, the email is created, but when you press SEND, the message "operation failed" appears. The address is fine. If I create a new message in outlook to the same address I have no problem.
What might have changed to cause this problem?
Recently the office upgraded to Exchange 2000. Now, the email is created, but when you press SEND, the message "operation failed" appears. The address is fine. If I create a new message in outlook to the same address I have no problem.
What might have changed to cause this problem?
