Openserver 5.0.6 and Digi MPI drivers

[backoftheworm]

I am currently running Openserver 5.0.5 on a Dell PowerEdge 6600. I am trying to upgrade to release 5.0.6. Before the upgrade, I uninstalled all third party apps. The upgrade completes succesfully. I then installed RS506A and OSS648A. Next I successfully install the Broadcom Gigabit Ethernet drivers, the Digi DRP drivers, Olympus Tuneup 6.0.0N, and finally Digi MPI drivers. Software Manager shows that all software is installed successfully. When I try to configure the MPI drivers with the MPI utility (#mpi), SCO reports #mpi: command not found. During the install of the MPI drivers, I can barely read a scrolling message that states GUNZIP: Operation can not complete. Any ideas or comments would be greatly appreciated.

 

[damccasl]

sounds like a corrupt install.
we are using version 2.9.1 because of problems with latest version

 

[shaeboy]

Download the latest driver release off of DIGI's website and it should load OK.