EastTexasUser
MIS
Today I replaced an old faithful HP LaserJet 4 Plus (which finally died) with a new Xerox Phaser 4400. I'm printing to the 4400 over a Lantronix LPS2 printserver. I am using the same HPLaserJet model. Is there a better model to use?
When I send a unix print job, the whole job prints, then after the last page the printer shows a message "receiving data" for about 10 minutes before it will finally go back to "ready". Is anyone familiar with this behavior?
When printing to the 4400 over the printserver in windows, it woks as expected. No hang at the end.
Any help would be greatly appreciated.
When I send a unix print job, the whole job prints, then after the last page the printer shows a message "receiving data" for about 10 minutes before it will finally go back to "ready". Is anyone familiar with this behavior?
When printing to the 4400 over the printserver in windows, it woks as expected. No hang at the end.
Any help would be greatly appreciated.