OneBox Gigi problem

[TJ79]

2 days ago I wanted to move the NIU board connected to OneBox via the network from LIM 2 to LIM 1. (LIM's are standing next to each other)

Unfortenately I couldn't get it working.

Commands I used: IONPC, VMPOE, VMFUE, ICFUE, BLDBI, IONCE, IOEQE, IOBPE, CNBOE, CNHUI, IOBPI, IOEQI, IOIFC, IOFDC,IONCI, ICFUI, VMFUI, VMPOI, IONPC

After the move when we looked at IONCP, TCP was missing in column PROC. The MD110 didn't give any fault.

We used the same cable as on the old position, I tried changing NIU, this didn't work, SFCEI (in case of problem Program Unit), stopping service and starting it again on te server, rebooted server, different hw positions in LIM 1, restarting the board. But all actions didn't solve the problem.

After putting the board back to old position in LIM 2 it worked again???

Does anyone know what I've forgotten? Maybe something with the server?

 

[doktor]

Try to restart ILNP and ILCP in LIM=1, when the NIU board is installed in LIM=1.
RFPUI:UNIT=ILCP&ILNP,LIM=2;
The PROC = TDC must be shown at all times, when using IONCP;
Post also your command files and printouts.
/// doktor