AS 11.5 sp4. I have two staged jobs that run at the same time as a job that runs direct to tape. When the direct to tape job finishes, the data migration faze of the staged jobs kicks off and starts to copy to tape. In the past, one job would run and the other job would wait until the tape drive was available again before starting the 2nd migration.
I had to do a server rebuild, and now the 2nd migration tries to start the copy job while he first one is running, and times out with a message: "Please mount a blank media or media not belonging to any pool media".
Both staging jobs are set up the same for destination device and are set to append to media. I don't know what setting I had turned on/off before that allowed the 2nd migration to wait until the first one completed.
Help please. TIA
Roger
I had to do a server rebuild, and now the 2nd migration tries to start the copy job while he first one is running, and times out with a message: "Please mount a blank media or media not belonging to any pool media".
Both staging jobs are set up the same for destination device and are set to append to media. I don't know what setting I had turned on/off before that allowed the 2nd migration to wait until the first one completed.
Help please. TIA
Roger
