Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

On Analog Euro2025 handset system time is not reflecting

Status
Not open for further replies.

persi01

Technical User
Sep 14, 2017
32
IN
Hi guys,

At os4000 system version 8.19 the analog handset euroset 2025C does not take time from system.
Normally euroset 2025c take system time once I make a incoming calls to it.

If connect same phone to ver7 system then it takes time from system.

Any parameter to be checked.
Any inputs are welcomed.
Thanks in advance.
 
And you need to check the battery/batteries
 
If it worked on V7 then it'll be delivered in the CLIP burst with an incoming call.

Check in FEASU that CLIP is active.

Also in ZAND ALLDATA3 you have CLIPSTD parameter, defining which CLIP standard to use. Compare that with your V7.
 
For CLIP to analog ports : SLMAE, SLMAV or SLMAC board is recommended.
SLMA24,SLMA3 board - not supported
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top