Older E&M TRK Dip Swtich Settings

[cdpak]

Does anyone have the older E&M Trk dip switch settings on a 9104-041-001-SA and are they the same as on a new 9109-013-000-SA. Thank you

 

[cwc3]

Don't count on it what does the sx-50 manual say?

 

[cdpak]

Could not find anything in the SX-50 manual. Which was the reason for the post.

 

[cwc3]

There are no explanation of dip switch settings in manual for that card ? I find that hard to believe do you want me to look and come back and tell you there is ? you could contact genesis tech support via email they'd know right off hand what the settings are?

 

[cwc3]

TABLE 6-5
E&M MODULE SWITCH FUNCTIONS
,witch I Function
I OPEN - PBX to Line = +3 dB
CLOSED - PBX to Line = -13 dB
I OPEN - 600 Ohm Balance Enabled
CLOSED - Complex Balance Enabled
2
3
OPEN - Line to PBX - -4 dB
CLOSED - Line to PBX = -1 1 dB
OPEN - Complex Balance Enabled
CLOSED - 600 Ohm Balance Enabled
7 (NOT USED I
5
6
OPEN - 4-Wire Operation
CLOSED - 2-Wire Operation
OPEN - Type 5 Signaling
CLOSED - Type 1 Signaling
Page 84
8 NOT USED
bte: The settings of Switch 3 and Switch 4 must agree. It is
not possible to have both 600 Ohm Balance and Complex
Balance enabled simultaneously

 

[cwc3]

http://genesis-communications.biz/Manuals/Mitel/SX50/SX50_MS53_54_Pocket_Ref.pdf

download this doc its on page 90 and took me a total of 5 mins to find it and it was in the book!!

 

[cdpak]

Thank You very much for the info.