Office Connect 221 (path not bound error)

[LookingForAnswers]

Whenever I attempt a loopback on this office connect 221(belive it has the boundry software) ,either via the command line or the menu, the router immediately locks up with the following error:

PANIC 4360548

bm_path_port_pathup: Path not bound to a port.
------------------------------
and then drops me into the >cl interface. I then have to disconnect the cables or connector, then reboot, verify that none of the loopback options (owner, clock etc..) are set. Then reconnect the cables. If I leave the connector or cables connected it will error out again.
I've some reference to the "sh diag" commands but they are not recognized by this or the main router. Beleive they are for a newer version of the os.
Currently running SW/NBRO-BX 9.1

any help or advice would be greatly appreciated.

 

[Brat]

Hi,

have you tried software v10.1? Try to load latest one and check again.

Brat

 

[LookingForAnswers]

Thanks Brat!
Having some difficulty locating that on 3Com's web site. Any idea where I can find the boot.68k file?

 

[Brat]

Hi,

Try ftp://ftp.3com.com/pub/swup/

you can find software there or try

http://support.3com.com/software/netbuilder.htm

Hope this help

Brat