OCX-troubles in VB on NT4

[CybOrg]

Hi all!
When trying to load a project (which loads and runs quite nicely on a W9x-machine) I get errors on the OCX's when I load them. Moreover - when I go into 'Project/Components' I get another System error (&H80004002), claiming the interface isn't supported. Clues, anyone?

 

[culshaja]

Sounds like you have got out ofdate components on your devlopment machine.
I think the component browser problem is something different though. Go to technet and check it out using the error code you give above. I think you just need to replce a file and it will clear up.

James James Culshaw
jculshaw@active-data-solutions.co.uk

http://www.active-data-solutions.co.uk

http://www.brainbench.com/transcript.jsp?pid=193305

 

[CybOrg]

Thanks - you were right. The answer was found in Technet, under the heading:

"Q175156 PRB: Class Not Registered Error and Empty Components Dialog"

Part of the trouble was that I use a Swedish version of VB6, thus get all the error messages in Swedish - Technet's in English. Anyhow - the problem file was COMCAT.DLL, which is delivered on the VB CD-ROM (but apparently not installed - thanks a lot M$!)

Cy Borg