Octel 250 refuses to recognize SEND key

[kevin906]

I have mapped "^[7" into Procomm using Wyse 50 emulation.
When I try it all I get is "7" in the data field, like something is stripping the "^[" off. The system is being accessed via the system modem, nothing fancy like termserver with direct connect. Any ideas?

Thanks, Kevin

 

[kxboy]

what is your terminal type set for in menu 6-3? "^[7" is the correct key. Did you enter "shift+6" then [ 7, when you mapped the key, or did you use the ctrl key?

You could also try changing the terminal type to something else in menu 6-3, then logging on, off, then change it back to wyse 50 and logging on again. I found this worked for me a couple of times when the terminal was not acting right.

 

[kevin906]

Term type is Wyse 50 in menu 6-3, matches the Procomm setup.
Did a "shift+6" when setting the key up. I thought changing the terminal type required a reload??

Thanks,