OBDCSTF.DLL won't open during .EXE installation

[xk120]

Using the Setup Wizard I built a set of installation disks to install my application on other desktops. I used the same proceedure many time in the past with great success. This time when I run the Setup it runs fine until it tries to open the ODBCSTF.DLL. I just reinstall VFP6.0 and it didn't help. Any suggestions??

Bob

 

[DEDMOD]

Don't know that specific .dll, but it may be that it's relying on another .dll which isn't being included in your installation disks. There are some neat tools available to let you see which other dlls a given dll requires. One I've looked at is found in

Visual Studio 6.0
Visual Studio 6.0 Tools
Depends

-- Dave