O250 adding sys drive fails

[YewNork]

Hi all,
getting the following error(s) when I try to add a drive 1:
Enter drive to be installed[0-5]: 1
Drive Serial No: JLxxxxx
Is this the correct drive? (y/n): y

Installing System drive 1. Please wait...
Error Code File Number Record
8e 32 00004bd8
8e 32 00004bd9
8e 32 00004bda
8e 32 00004bdb

ERROR - Fatal error initializing destination drive.
Press any key to continue.

Can someone help? Thanx...

LDS (TELUS)

 

[KenMeans]

well yes it is telling you the drive you are trying to add is bad and can't be initialized.

Have you tried a different drive?

Ken Means

http://www.tel-is.com

"I find that the harder I work, the more luck I seem to have."
- Thomas Jefferson (1743-1826)

 

[KenMeans]

well yes it is telling you the drive you are trying to add is bad and can't be initialized.

Have you tried a different drive?

Ken Means

http://www.tel-is.com

"I find that the harder I work, the more luck I seem to have."
- Thomas Jefferson (1743-1826)

 

[YewNork]

Thanx, but I have tried another drive with the same result. BTW, I can enable both drives in another system.
I'm suspecting problems on the currently working drive 0.
Thoughts?

LDS (TELUS)

 

[KenMeans]

that is possible but the error is saying it can't init the destination not the source.

Did this system ever have a drive 1 or has it always been a 1 drive system?

At one time they had systems that you could only have one drive in and this may be one of them.

If you look at the tag on the back is it a 250 or some other odd name?

Also can you post he error from the status log ?

Ken Means

http://www.tel-is.com

"I find that the harder I work, the more luck I seem to have."
- Thomas Jefferson (1743-1826)

 

[YewNork]

Thanks for the reply Ken,
<Did this system ever have a drive 1 or has it always been a 1 drive system?>
It's been 2 drives up until a power outage. The original intent was to replace drive 1

At one time they had systems that you could only have one drive in and this may be one of them.

<If you look at the tag on the back is it a 250 or some other odd name?>
Definitely an O250

<Also can you post he error from the status log ? >
I'll try tomorrow from the office..

Thanx again


LDS (TELUS)

 

[kxboy]

Try replacing drive 1, or un-installing drive 1, then installing the new drive. If the old drive failed, and it was not removed or un-installed completely, a install of drive 1 will fail

 

[KenMeans]

Ya if drive one is still installed that might be it.

Ken Means

http://www.tel-is.com

"I find that the harder I work, the more luck I seem to have."
- Thomas Jefferson (1743-1826)