NTP on a 1720

[cpace]

How do I set the time and allow a 1720 to use NTP ?
I used the same commands I use on the 2621.
NTP clock-period 17180280
ntp server 192.43.244.18

I cannot get the 1720 to recognize these commands.

 

[jeter]

Check out this site.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_5_5/sw_cfg/ntp.htm#23307

“Reserve your right to think, for even to think wrongly is better than not to think at all”

Fisher CCNA,(CCNP-Routing)
UOP Student BSIT

 

[ChrisAC]

cpace, those commands are still correct for a 1720. This is copied from my 1720 ....


collossus#conf t
Enter configuration commands, one per line. End with CNTL/Z.
collossus(config)#ntp ?
access-group Control NTP access
authenticate Authenticate time sources
authentication-key Authentication key for trusted time sources
broadcastdelay Estimated round-trip delay
clock-period Length of hardware clock tick
master Act as NTP master clock
max-associations Set maximum number of associations
peer Configure NTP peer
server Configure NTP server
source Configure interface for source address
trusted-key Key numbers for trusted time sources

collossus(config)#ntp

Chris.
************************
Chris Andrew, CCNA
chrisac@gmx.co.uk
************************