NTDK20JA SSC card

[nortelcs100e5]

Hi all, i have a SSC card having Eng. code NTDK20JA, can i install Release 5 software with that SSC card? does it works ok?

 

[M1tel]

This is a mouthfull but it sould help

For CS 1000 Release 5.5 software, the minimum requirements are:
• 32 Mbyte DRAM
• 16 Mbyte primary ?ash
• 48 Mbyte program store
Note: The NTDK97 Mini System Controller (MSC) card, which has
16 Mbyte DRAM, is not supported for CS 1000 Release 5.0 and
later. The software cannot ?t on the 32 MBytes of program store on
the MSC card. Refer to Note 3 at the bottom of Table 21 "System
controller card requirements for Small Systems" (page 84) for details.
An NTDK20 SSC card with 32 Mbyte DRAM and equipped with an NTTK13
or NTTK25 Software daughterboard meets the minimum requirements.
New systems are shipped with the NTDK20HA SSC card equipped with the
NTTK25CA Software daughterboard.
Existing Cabinet or Chassis systems equipped with earlier vintages of the
SSC card must:
• upgrade the SSC card using the NTDK19 SSC upgrade kit
• if necessary, upgrade to the NTTK25 Software daughterboard
Note: If you are installing a new software daughterboard on an older
vintage SSC card, you must upgrade the boot code on the SSC card
before installing the new daughterboard.

System controller card requirements for Small Systems
System configuration Main Cabinet/Chassis Expansion Cabinet/Chassis
Single cabinet • NTDK20HA SSC
• Upgraded NTDK20AB-GA
SSC (see Note 2)
n/a
Fiber expansion Cabinet
system
• NTDK20HA SSC
• Upgraded NTDK20AB-GA
SSC (see Note 2)
n/a
(use Fiber Receiver card)
IP expansion Cabinet
system
• NTDK20HA SSC
• Upgraded NTDK20EA-GA
SSC
NTDK20HA SSC
Upgraded NTDK20AB-GA SSC
(see Note 2)
Single chassis • NTDK20HA SSC
• Upgraded NTDK20EA-GA
SSC
• NTDK97AD MSC (see Note
3)
n/a
Fiber expansion Chassis
system
• NTDK20HA SSC
• Upgraded NTDK20EA-GA
SSC
n/a
(use Fiber Receiver card)
IP expansion Chassis
system
• NTDK20HA SSC
• Upgraded NTDK20EA-GA
SSC
• NTDK20HA SSC
• Upgraded NTDK20EA-GA
SSC
Note 1: The term upgraded NTDK20xx refers to an SSC card vintage NTDK20xx on which the
NTDK19 Upgrade Kit is installed.
Note 2: NTDK20AB/CA Rls. 1-5 is not supported on upgrades. Refer to Product Bulletin
P-2004-0067-Global.
Note 3: Maximum capacity in a TDM solution is 160 TDM TNs and 2000 Corporate Directory entries.