NTAK79BCE5

[someguy758]

Hello, We have a NTAK79BCE5 2MB PRI card and trying to use it in a CS1000E v5.50J. When I try to enable in LD 96 i get;

DCH000 .
stat msdl
MSDL 004 0 4 MAN DSBL

.enl msdl 4 0 4 MSDL016

D-Channel Configuration:
ADAN DCH 0
CTYP MSDL
MG_CARD 004 0 04
PORT 0
DES
USR PRI
DCHL 2
OTBF 32
PARM RS422 DTE
DRAT 64KC
CLOK EXT
IFC EURO
CNTY ETSI
PINX_CUST 0
ISDN_MCNT 300
CLID OPT1
PROG NCHG
CO_TYPE STD
SIDE USR
CNEG 1
RLS ID **
RCAP ND2 COLP
MBGA NO
OVLR NO
OVLS NO
T310 120
INC_T306 120
OUT_T306 120
T200 3
T203 10
PAGE 002
N200 3
N201 260
K 7

We have 2 of these Cards both giving same message.
What's wrong?

Thanx

 

[bigindian65]

is that a TMDI? Did you config clock in 73 and enable it in 60 for each card?

Mato' Was'aka

 

[Aerodesliza]

Check the TMDI in LD 96 stat TMDI. disable and enable again, check the Dchannel and do the same.

 

[layzee]

the NTAK79 card is not a msdl....
the card you require for the "Euro" type of cct is the
NTBK50

 

[someguy758]

This card cannot work for the setup shown?
If not, what is and where is this card primarily used?
How is it configured? I have been unsuccessful in finding documentation on this card and how to configure it.

Thanks

 

[layzee]

in the uk this card would be used on a DASS / DPNSS
cct
you have configured in the adan data block an msdl (which would be for a ntbk50 with a downloadable daughterboard )

if you wish to configure the ntak79
it is done in ld 74 / 75 with a ddsl / ddcs

 

[bignose21]

It can also be used for MCDN (SL1) meridian interworking programmed as DCHI

 

[rsenu]

Hi,

How can i check MCDN in 11c 25.40b rls.If i define NTAK79BB for SL1 then this s/w will automatically detect this MCDN protocol...

 

[bignose21]

SL1 / MCDN same thing