NT Client for MS-DOS, I need other program but don't have memory

[Israel]

Can you help me ?

I have a PC with NT client for MS-DOS it's install correctly. I logon in the PDC and I can see the BDC resources. I need run another program (control for employee tarjets terminals) , but the PC don´t have conventional memory, how load client modules in extended memory. I try with hidevice, EMM386, Memmaker, Himen, LH, nothing solve my problem, sugerences...

Thanks

 

[mikes999]

To load the clients in the extended memory, you have to use "try-and-error" approach, that is, try every single client module to load into highmem, and verify if it works. Sequence of loading is also important. Also, try to remove one module at a time - for the task you mentioned, you might not need all the networking services you loaded (don't go with Microsoft's default, as usual ).

How big is your DOS program? Try to determine, how much free memory you actually have after the boot.

Good luck - it's a tough one...