NT 4.0 Restore Fails

[pi1220]

I am trying to restore an NT 4.0 machine.
My enviroment is
Brightstor V9 with service pack installed
Restore machine Compaq 1850 with 2dh Raid Controller
Running NT 4.0
All hardware is found.
I try to do a remote restore and after I put in the machine specific disk and do a reboot it blue screens with inaccessable_boot_device.
So I built the machine with a bare version of NT 4.0 on it and did a restore of the C: drive and it wouldn't boot it did a NTkernal.exe not found. Does anyone have tips or an article on how to do a restore of NT 4 using arcserve. I would like to use the DR but for now I just need to have a working plan of restoring NT 4 machines.

Any Help would be greatly appreciated

 

[JPCPB]

Greetings,

I found this article on CA's website - although it doesn't mention ARCServe v9:

http://support.ca.com/techbases/asnt/16046.html

The following has a few caveats regarding OSes and DR Options - scroll down to the section entitled "Disaster Recovery Options":

http://support.ca.com/techbases/basb9/basb9_faqs.html

I'd suggest that you check with CA (you have a support agreement?) before proceeding.

Kindest regards,

James