Just a FMI question. What do you guys use or do with wiring from the NS700 when the voice cables are terminated on 110 or 66 blocks? I am looking for something more modular friendly, Leviton has some cool stuff. I installed Norstar for 25 years that's why I am asking a lot of newbie Panasonic questions. Thanks for your help...again!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
NS700 Wiring
- Thread starter Merbac
- Start date
obtsystems
Programmer
We use Krone blocks, over here and if the voice cables are terminated on krone blocks. I would use cat5 cables patched to the system and other end terminated to krone blocks in order or ports on the system. then use jumper cable to patch from system side to wiring side on krone frame
To keep tidy, I would remove old jumper cable if moving extension to new port and replace with correct length of jumper cable
To keep tidy, I would remove old jumper cable if moving extension to new port and replace with correct length of jumper cable
- Thread starter
- #3
Unfotunately, image not clear enough. Am also not sure if the pins used on KX-NS700 are same as on KX-NS500. We use KX-NS500 here. I will check the KX-NS700 Installation manual
obtsystems
Programmer
that picture shows a cat5 panel and not a 110 block
as far as I know the wiring is the same on the 500 and 700 as the 700 is based on the 500 system
as far as I know the wiring is the same on the 500 and 700 as the 700 is based on the 500 system
- Thread starter
- #6
The bottom part of the picture (that you can't see) has 110 pins. This way I can just cross wire to the destination, much easier than cutting off the connector from one side of the patch cable, punching it on a 110, punching down a c-4 and THEN cross wiring. I will probably just buy one and try it. Thanks again.
obtsystems
Programmer
you could do that, but as time and changes are made to the system. it could get very messy/untidy
- Status