NS700 - LCOT6 card recognised as a BRI4?!

[S435]

I'm at a loss as to what to try, but no amount of deleting and pre-installing a LCOT6 module on the web interface helps, the PBX insists (and even shows the module in service) the module is a BRI4 module. The module has the correct appearance of an LCOT6 otherwise I would be entirely convinced it was a BRI4 labelled incorrectly.

Firmware version is 008.03023.

I have two other NS700s which are on older firmwares and have never had this kind of issue before.

 

[Ired]

Try this module on any other PBX.

 

[S435]

Thanks - just this second did and same behaviour, guess that'll be going back!

 

[omonat]

Are u installing it in the appropriate slot?. The cards are slot-specific

wanetelecoms@gmail.com