OK, this is a strange one.
Customer has a MICS 7.1 with CP150 Release 3.1 with a PRI.
Company has two target lines pointed at different greeting tables. Works just fine until you connect to the FastRad and use the browser tool. The target line going to greeting table 2 reverts to greeting table 1 after you go into the browser tool threw the rad. The only way to fix this is to reboot the CallPilot, then it works fine.
I had it tested before hooking up the rad and browser tool, then used the browser tool, and it magically reverts back to table 1.
Anyone ever seen anything like this???
Might be the strangest thing I've seen on a Norstar yet.
Customer has a MICS 7.1 with CP150 Release 3.1 with a PRI.
Company has two target lines pointed at different greeting tables. Works just fine until you connect to the FastRad and use the browser tool. The target line going to greeting table 2 reverts to greeting table 1 after you go into the browser tool threw the rad. The only way to fix this is to reboot the CallPilot, then it works fine.
I had it tested before hooking up the rad and browser tool, then used the browser tool, and it magically reverts back to table 1.
Anyone ever seen anything like this???
Might be the strangest thing I've seen on a Norstar yet.
