NRS failsafe on CS1000 REL. 6

[mattia81]

I have a CS1000 CPPM Rel.6 with cores. I configure two servers UCM with primary and alternate NRS. Now I have to configure on the CPPM Cores the Failsafe NRS. How do I do? I configure the NRS with the addresses of the primary and the alternate NRS or is there some other procedure?
Thank you

 

[allenmac]

Go into element manager for the cores system, and navigate to System>>IP Network>>IP Telephony Nodes.

If you have already set up your Node, then click on the Node ID, and then in the upper window, click on the 'Gateway (SIPGw & H323Gw) link. When the window opens in the General Pane, there is a checkbox called 'Enable failsafe NRS'. Just make sure you check that box.

If you have not already set up your node, then when you do and you are setting up the Virtual Trunk Gateway Configuration Details, you will see the 'Enable failsafe NRS' checkbox. Check it.