Notify Me to Numeric Pager

[jaja2468]

I am totally untrained and new to modular messaging. I have configured a class of service with the notify me option and assigned it to a mailbox. I launch subscriber options and configure to allow paging to a pager number. However, it does not work.
What is the call path that would be used to perform this function and what other areas do I need to make this possible.

 

[tommyboy23]

Subscibers Options Need to add Phone List +9,1xxxxxxxxxx&,,,(Voicemail box extension)#

Then Check the Notify Me Automatic Notification
check Automatic Notify me Rule.

Make sure you have outbound routing for your modular messaging.

 

[jaja2468]

Thanks Tommyboy. I think what is missing is the outbound routing for the modular messaging. I did the subscriber options as you suggest but not getting even a partial page.

Where could I verify outbound routing?

 

[tommyboy23]

How are you connected to MM? QSIG SIP?

 

[jaja2468]

Yes our connection is via SIP

 

[tommyboy23]

Ok Session Manager/System Manager or Sip Enablement Server? Does your Find Me Call Me work if so you should be able to page. If it's the Enablement Server check you Map?

 

[KenMeans]

does it work if you use a ext number on the pbx as the dialed number ?


Ken Means

http://www.tel-is.com

"I find that the harder I work, the more luck I seem to have."
- Thomas Jefferson (1743-1826)

 

[jaja2468]

Sorry for not responding sooner. If an internal PBX number is used for the Pager, MM does dial that number and I can hear the digits.

Also did a list trace on the trunk grp for MM and got the following error when an external pager nnumber was provisioned.

SIP>SIP/2.0 404 Not Found

So I am guessing that we do not have a route out of the CM? Where to look next?

 

[kepetersen]

404 usually means a denial event. Is the FRL number on the CM 4 or higher?

 

[jaja2468]

We have a resoultion to our issue. It appears there was no dialing plan built in our session manager. Thank you for all the replies.