Have two workstations that will not use the btrieve 6.15.451 server engine, where the databases reside. Using filemon, they load up the correct dll's required for the server connection. But then stop and switch back to the w32mkde.exe (wrkst) engine. One workstation is windows 95b the other is NT 4.0 sp6a. We have recreated the bti.ini in the default windows folder. Renamed the Btreive Technologies Section in the Registry. (we use [Btrieve] Thunk = yes) in the bti.ini. Re-checked the engines settings, to make sure that local = yes and requester=yes in the registry. We have run the diag10 utility. (only TCP loaded) Runs clean. Any ideas?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Not switching from workstaiton to server engine correctly
- Thread starter rk16
- Start date
Just to confirm, the data files being open are on the server?
What happens if you change to Local=No in the registry? Do you get a status 20 or some other status code?
mirtheil@mirtheil.com
Custom VB and Btrieve development.
Certified Pervasive Developer
Certified Pervasive Technician
What happens if you change to Local=No in the registry? Do you get a status 20 or some other status code?
mirtheil@mirtheil.com
Custom VB and Btrieve development.
Certified Pervasive Developer
Certified Pervasive Technician
- Status