Just configured a call centre phone. For some reason when logged in it does not display not ready status on the phone but does through Symposium. Replaced phone and still the same, and checked the configuration and its the same as other call centre phones. Any ideas to what could be wrong???
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Westi on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Not ready not displaying pn phone
- Thread starter ianclarke
- Start date
If its a 3900 series phone try updating the Firmware on the phone in ld 32. Do an FDLU XXX.X.XX.XX (TN). Just make sure you de-acquire it first.
Not sure what to tell you if its not a 3900 series phone and its still not doing it. What revision of PBX software are you on?
Not sure what to tell you if its not a 3900 series phone and its still not doing it. What revision of PBX software are you on?
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question