I recently purchased a clariion FC5310 iDEA and a single DAE
and I've gone through the posts about using the serial
console to get to the fcli> prompt. I'm actually plugged
into the SPS which is connected to the iDEA, but I don't
know if it makes any difference.
I'm able to break out of the "Entering Serial Application
Mode" by typing @$@$, which give the following menu:
DIAGNOSTIC MENU
1) Hard reset 9) Tachyon Menu
2) Enter Debugger 10) FLARE Menu
3) All POSTs 11) PROM Menu
4) PROM Rev 12) L1Cache Menu
5) POST menu 13) DISK Menu
6) RAM Menu 14) Set ICACHE
7) Nonvol Menu 15) Set DCACHE
8) FRUMON Menu 16) JBOD MODE
I've gone through the options that have "menu" and haven't
seen anything for fcli. Does anyone have any ideas
on what I could try?
Thanks
Mark
and I've gone through the posts about using the serial
console to get to the fcli> prompt. I'm actually plugged
into the SPS which is connected to the iDEA, but I don't
know if it makes any difference.
I'm able to break out of the "Entering Serial Application
Mode" by typing @$@$, which give the following menu:
DIAGNOSTIC MENU
1) Hard reset 9) Tachyon Menu
2) Enter Debugger 10) FLARE Menu
3) All POSTs 11) PROM Menu
4) PROM Rev 12) L1Cache Menu
5) POST menu 13) DISK Menu
6) RAM Menu 14) Set ICACHE
7) Nonvol Menu 15) Set DCACHE
8) FRUMON Menu 16) JBOD MODE
I've gone through the options that have "menu" and haven't
seen anything for fcli. Does anyone have any ideas
on what I could try?
Thanks
Mark