Not able to access OWA after enable SSL

[seekerhk]

I will recieve an error message when I tried to access OWA logon page. However it was happened only after I enable the forms-based authentication as well as SSL on my IIS server.

Can anyone help!

 

[markdmac]

Are you using HTTPS instead of HTTP? Did you redirect port 443 to the Exchange box?

I hope you find this post helpful.

Regards,

Mark

Check out my scripting solutions at

http://www.thespidersparlor.com/vbscript

 

[seekerhk]

Hi Mark,

I did use HTTPS for accessing the OWA logon Page. Actually I have followed all the steps in configuration of OWA to use SSL. I can accessing the normal Exchange logon Page by using HTTP but once I enable the SSL then I cannot accessing the OWA logon page via HTTPS. The error message was the page cannot be displayed.

Best regards

Seekerhk

 

[markdmac]

Did you redirect port 443 to the Exchange box?

I hope you find this post helpful.

Regards,

Mark

Check out my scripting solutions at

http://www.thespidersparlor.com/vbscript

 

[seekerhk]

Mark,

Where should I go for redirecting the port 443 to the exchange box

Thanks

 

[markdmac]

On your firewall or router.

I hope you find this post helpful.

Regards,

Mark

Check out my scripting solutions at

http://www.thespidersparlor.com/vbscript

 

[58sniper]

See if you can get to the box over HTTPS internally, or even at the server console.

If that doesn't work, disable Forms Based Authentication and try it again over HTTPS. Let's narrow down where the problem is.

Also, check the event logs.

Pat Richard, MCSE MCSA:Messaging CNA
Want to know how email works? Read for yourself -

http://www.ietf.org/rfc/rfc2821.txt