Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Nostar 0x32 6.1 backup restore RAD

Status
Not open for further replies.

mercuriotelecom

IS-IT--Management
Nov 11, 2008
25
MX
if i have Rls 6.1 backup can i restore entire programing on another 0x32 ?

Thanks
 
Yes as long as it is the exact same software.
If it had a PRI Enabler that would need to be migrated via KRS/Ticket to the new SYSID

________________________________________

Add me to LinkedIN

**New Allworx Forum**

small-logo-sig.png

=----(((((((((()----=
Toronto, CAN
 
And do you have the command to setup a calls in mexico region 2, the commands inside r2mfc card in the manual comes the nostar ox32 parametroa

thanks

I have a manual of r2mfc card, i install the card and make outside calls i cant recive calls ... looks strange

Thanks.
 
I do not know sorry.
For inbound calls start with "Target Lines" and make sure you have programmed the received digits.
If the Carriers sends 4 digits then program the last 4 digits of the phone number.

I don't know if this helps, some of it might:

As for backup with the RAD I should have mentioned you must install the same modules and cards for it to boot up proper.


________________________________________

Add me to LinkedIN

**New Allworx Forum**

small-logo-sig.png

=----(((((((((()----=
Toronto, CAN
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top