Hello,
I have a Nortel CS1000 and im seeing an issue with one ISDN_PRI vendor. Instead of detecting busy tones as CAUSE: #17 - USER BUSY, the PBX is detecting busy tones as CAUSE: #31 - NORMAL UNSPECIFIED.
This is only happening with one vendor.
The rest of PRI circuits work fine (detect the busy....as busy) and all circuit are set up the same.
Is it possible to do osme fine tunning on the Nortel.
D Channel is set up this way:
ADAN DCH 29
CTYP MSDL
GRP 0
DNUM 8
PORT 3
DES test_orantge
USR PRI
DCHL 29
OTBF 32
PARM RS422 DTE
DRAT 64KC
CLOK EXT
IFC EURO
CNTY ESP
PINX_CUST 0
ISDN_MCNT 300
CLID OPT1
PROG NCHG
CO_TYPE STD
SIDE USR
CNEG 1
RLS ID **
RCAP COLP
MBGA NO
OVLR NO
OVLS NO
T310 120
INC_T306 0
OUT_T306 50
T200 3
T203 10
N200 3
N201 260
K 7
I have a Nortel CS1000 and im seeing an issue with one ISDN_PRI vendor. Instead of detecting busy tones as CAUSE: #17 - USER BUSY, the PBX is detecting busy tones as CAUSE: #31 - NORMAL UNSPECIFIED.
This is only happening with one vendor.
The rest of PRI circuits work fine (detect the busy....as busy) and all circuit are set up the same.
Is it possible to do osme fine tunning on the Nortel.
D Channel is set up this way:
ADAN DCH 29
CTYP MSDL
GRP 0
DNUM 8
PORT 3
DES test_orantge
USR PRI
DCHL 29
OTBF 32
PARM RS422 DTE
DRAT 64KC
CLOK EXT
IFC EURO
CNTY ESP
PINX_CUST 0
ISDN_MCNT 300
CLID OPT1
PROG NCHG
CO_TYPE STD
SIDE USR
CNEG 1
RLS ID **
RCAP COLP
MBGA NO
OVLR NO
OVLS NO
T310 120
INC_T306 0
OUT_T306 50
T200 3
T203 10
N200 3
N201 260
K 7
