Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Nortel / Norstar MICS, new Trunk DID number

Status
Not open for further replies.

Error707

Technical User
Jun 19, 2020
4
US
Hi Guys, I have an old Nortel / Norstar system, we had a DID on it and everything worked fine, we had to port the DID out and we had a new DID assigned. How do I update the new DID in the nortel / norstar system? Right now I can't make or receive calls and I assume it is because the new DID does not match what is in the system. (This is a PRI trunk)

TIA
 
I believe I found the "target line" but I don't see the old DID being listed anywhere there.
I believe my target line is 225
I found it by going to "Lines">225>Show>Trunk/Line data>"Target Line">Next>"Line Type: Public"

I was also able to go to Terminal Sets>225>Line Acces>OLI:(which lists the old DID)
 
View your line #
Go to Set's/XXX/LineAccess/LineAssignment/ to see what Line # is assigned to your set.

Received digits
Your not going far enough in programming
Go to Lines">225>Show>Trunk/Line data> Next, Next >Received Numbers>Next >Pub




________________________________________
small-logo-sig.png


=----(((((((((()----=
Toronto, Canada

Add me to LinkedIN
 
Hi curlycord, thanks for the reply. I am a noob to this so hopefully I get this right. I believe my main Operator extension is 225, which is also what I believe all the calls come into first.

When I goto:
"Set's/225/LineAccess/LineAssignment/ " it prompts me with "Show Line:" if I enter 225, it says "L225:Unassigned"
If I go back and say "Show" I get "L001:pRI-B" I get PRI-B for L001 to L023, after which it is PRI-A



 
When in line assignment push the "scan" button to see what lines are assigned.

You do not assign the PRI lines, only Target Lines.

Your best to call a tech especially if you cannot dial in or out.



________________________________________
small-logo-sig.png


=----(((((((((()----=
Toronto, Canada

Add me to LinkedIN
 
When I press scan for 225 i get L157:Appr&Ring
This is no longer a production system, so I figured I would take this opportunity to learn how to do it.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top