Nortel MICS with Centrex software

[Osberntoe]

I'm brand new to Tek Tips, so I would appreciate any advice or suggestions.
I am working on an old Nortel MICS with Centrex software cartridge. The
customer had all of her analog centrex lines from AT&T converted to POTS.
As her vendor, I discovered none of her Line Pool A phones could call 1+.
I spent two days trying everything I could think of. I finally discovered
that phones in Line Pool B could call 1+. My question is this. Is Line
Pool A restricted from calling 1+ ? If so, can I remove dialing restrictions
from Line Pool A ? Thanks for any help.

 

[allworxguy]

Restrictions are applied to sets or lines, not line pools.

Marv ccna

http://www.telemarv.ca

Sales, Installation & Service for Norstar, BCM, Samsung & Allworx Serving Ottawa and Eastern Ontario since 1990

 

[tball1]

If the restriction was on the norstar you should get restricted call showing up on the phone you are calling from

 

[SYQUEST]

When you attempt to place 1+ calls on Pool A, do you get a non completion recording? Since the Pool A lines were converted, did you test 1+ on the lines with a butt set? There is the possibility those lines have no PIC or LPIC assigned for long distance. 700-555-4141 should give you a recording from the long distance company assigned to the line. You will want to test each one.

....JIM....