Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Nortel MICS 2.0 -> 3.0

Status
Not open for further replies.
hashtagpoundsign

hashtagpoundsign

Programmer
Jun 20, 2012
26
CA
I know that there are some similar threads on this site to this upgrade but none really specify what I want to know.

I have a MICS on 2.0. The client now (after 10 years) wants call id. Does the 3.0 software support CID? I have already inserted the CI card but 2.0 did not support it. Also if there is anything else I'm missing I would love to hear what.

Thank you
 
Sort by date Sort by votes
Programming needed.
Go into Capabilities/Telco features and make sure Caller ID is set to Y.
Or old programming General/Option 9
On systems prior to 6.1 only 1 set gets auto caller ID, the rest must press F811 to see caller ID
Lines must be programmed to Ring and not just Appear for the auto call ID.
Caller ID is sent between 1st and 2nd ring on POTs lines.







=----(((((((((()----=
curlycord
 
Upvote 0 Downvote
Thanks for the quick reply allworxguy. What version would I have to go up to to support more than one set per line?
 
Upvote 0 Downvote
Forgot the obvious and that is you must pay for caller id from the carrier unless included in a package.

Also you do not have to go to 3.0....all versions of MICS/0X32 support Caller ID.

Actually that's a horrible idea, if you want to upgrade in future to get new features and be up to snuff then go to 7.1.
Anything else is a complete waste of money.




=----(((((((((()----=
curlycord
 
Upvote 0 Downvote
Also you do not have to go to 3.0....all versions of MICS/0X32 support Caller ID."

So assuming that my client is paying for caller ID my MICS running 2.0 should have caller id?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

N
  • Locked
  • Question
Need support on dial 9 Nortel MICS PRI When dial 9 display states Invalid number. Incoming DIDS work fine. Been working for years. Provider 1
Replies
6
Views
661
Nortel dino
N
kmpp
  • Locked
  • Question
Nortel Call Pilot
Replies
6
Views
273
curlycord
curlycord
S
  • Locked
  • Question
Nortel Meridian w/ Norstar Flash CCR issue 2
Replies
11
Views
1K
Synapt
S
RedMaligator
  • Locked
  • Question
Nortel MICS connected to Call Pilot
Replies
10
Views
250
curlycord
curlycord
roycep
  • Locked
  • Question
Nortel Norstar: Remove one extension from night ringing group 1
Replies
3
Views
218
roycep
roycep

Part and Inventory Search

Sponsor

Back
Top