Nortel - ISDN - Static routes dissappearing

[sydsec]

I have configured a Nortel ASN to call a remote site via a 30 channel ISDN macro link. I have configured the destination address under the 'Static Route' option. However, if I display (show ip route) via a telnet session, the static routing info for the destination address dissappears then re-appears?
If I reboot the router & show the circuit info, the circuit is up, then down several minutes later.
Call call is never established.

Any idears?

 

[siepratm]

Hello Sydsec, i´ve seen your thread but now. Do you still have this problems? If yes, i think i can do anything for you.

MS