Nortel IP phones and Cisco 2960 POE

[sdeokiesingh]

Was any resolution given to thread902-1399642

I'm trying to power an i2002 with a 2960 POE switch and no luck.

Any suggestions to make it work?

 

[VinceWhirlwind]

Shouldn't be a problem - do a "show power inline".

 

[sdeokiesingh]

Switch4RustStreet>show power inline

Module Available Used Remaining
(Watts) (Watts) (Watts)
------ --------- -------- ---------
1 370.0 52.4 317.6
Interface Admin Oper Power Device Class Max
(Watts)
--------- ------ ---------- ------- ------------------- ----- ----
Gi1/0/1 auto off 0.0 n/a n/a 30.0
Gi1/0/2 auto off 0.0 n/a n/a 30.0
Gi1/0/3 auto off 0.0 n/a n/a 30.0
Gi1/0/4 static off 30.0 n/a n/a 30.0
Gi1/0/5 auto off 0.0 n/a n/a 30.0
Gi1/0/6 auto on 7.0 Ieee PD 2 30.0
Gi1/0/7 auto off 0.0 n/a n/a 30.0
Gi1/0/8 auto off 0.0 n/a n/a 30.0
Gi1/0/9 auto off 0.0 n/a n/a 30.0
Gi1/0/10 auto off 0.0 n/a n/a 30.0
Gi1/0/11 auto off 0.0 n/a n/a 30.0
Gi1/0/12 auto off 0.0 n/a n/a 30.0
Gi1/0/13 auto off 0.0 n/a n/a 30.0
Gi1/0/14 auto off 0.0 n/a n/a 30.0
Gi1/0/15 auto off 0.0 n/a n/a 30.0
Gi1/0/16 auto off 0.0 n/a n/a 30.0
Gi1/0/17 auto off 0.0 n/a n/a 30.0
Gi1/0/18 auto off 0.0 n/a n/a 30.0
Gi1/0/19 auto off 0.0 n/a n/a 30.0
Gi1/0/20 auto off 0.0 n/a n/a 30.0
Gi1/0/21 auto off 0.0 n/a n/a 30.0
Gi1/0/22 auto on 15.4 AIR-AP1142N-A-K9 3 30.0
Gi1/0/23 auto off 0.0 n/a n/a 30.0
Gi1/0/24 auto off 0.0 n/a n/a 30.0

Interface Gi1/0/10 is where the phone is plugged into. Exact phone and cable works with a smaller SG300-10P

 

[VinceWhirlwind]

If the same switchport works fine with the same cable for a different phone, then I wonder if the phone itself is faulty?

Maybe you could try forcing the inline power from auto to "max 15400", for example. Or try it on "static".