Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Nortel ERS5530 Routing question

Status
Not open for further replies.

KCFLHRC

Technical User
Aug 16, 2011
6,082
US
Does anyone here know the command line for adding a static route to a Nortel ERS5530? The route is added and enabled but shows INACTIVE. How do you make it ACTIVE?
 
ip pim static-rp enable

You have to enable the protocol/service. Typically before you enter the static route.
 
There are a total of 9 static routes, 1 thru 8 show enabled active. Entry 9, the new entry, shows enabled inactive.
 
Curious then if you have sent traffic that route's way yet? It might need to actually use the route before it will show it as an active route.
 
That would be my guess too, it needs to see traffic
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top