Nortel E1 Opt 61 to Alliance IQMX

[Nortelshop]

We have a option 61c merdian with E1's programmed from the Nortel to a Alliance Turret phone system. does anytone have any ideas why the Nortel doesnt pass all the digits to the Alliance Turret system? I have checked the configuration for the both programmings of the E1's and they match. It only sends them out some of the time. Other times it has nothing?? Any suggestions?

 

[911guru]

PRI2 or DTI2? The main reason is that on PRI2 the digits for the called number are sent in a SETUP message, and on DTI2 they are sent via DTMF in-band.

What troubleshooting have you done to determine thatthe digits are not being sent from the Nortel?

911Guru

http://pbx-e911.com

E911 FAQs are located at:

http://www.tek-tips.com/faq.cfm?pid=798&handle=911guru

 

[Nortelshop]

I have only comapred the two PRI2 ands that is it. I dont know what else I can do. Suggestions?

 

[911guru]

Ok, you say

does anytone have any ideas why the Nortel doesnt pass all the digits to the Alliance Turret system?

What indicator of this do you have? Have you looked at the DCH messaging? Is overlap signalling turned on? Ned much more information.

911Guru

http://pbx-e911.com

E911 FAQs are located at:

http://www.tek-tips.com/faq.cfm?pid=798&handle=911guru