Nortel E1 connection with CISCO CME voice router

[musharraf]

Hi, I m a nortel Tech and need some help from CISCO gurus in following.
We have a CS1000 Release 5 (nortel PBX)which needs to be TIE to CISCO CME through E1, QSIG. The CISCO gut need clear requirement need to be setup at CISCO CME voice router. They say that they have E1 and QSIG availability at CISCO CME but need requirement/configuration to be setup at CISCO CME voice router to be needed to connect it with Nortel PBX.
I am not sure what setting/config should be done at CISCO CME voice router to get it talk with Nortel PBX using E1.
Can you guys post a sample configuration to configure CISCO CME voice router or point a document where i could find setting of CISCO CME Voice router with Nortel PBX.
I will be very thankful if somebody help.
Regards

 

[Minue]

Hello
I just starting studying for an up comming VOIP project for a new client.So I am not very skill,but the below conf should be a good starting point to get the line up.Will try to find you qsig specific conf.

network-clock-participate slot 1
network-clock-select 1 T1 1/0
!
!
controller T1 1/0
framing esf
clock source line
linecode b8zs
ds0-group 1 timeslots 1-24 type e&m-wink-start
!
end

Regards