Nortel Cisco Tie

[grnichol]

We have tied a nortel cs1000 5.0 (opt 81) to a cisco call manager with 2 qsig pri's. Every thing is working between them fine but we are now getting the following error none stop. Does any one know what might be causing this.


AUD083 070A93E0 00000C87 00000000 0000DD80 00000000 00000F01 00000000 00000001 0
000002E
0000000E 00000000 0000DD80 00000000

AUD083 0716B768 00000C87 00000000 0000DD00 00000000 00000F01 00000000 00000001 0
000002E
0000000E 00000000 0000DD00 00000000

 

[johnpoole]

are your msg lamps working to the cisco.. do you have qmwi in rcap?

john poole
bellsouth business
columbia,sc

 

[grnichol]

im not using voicemail on the cisco phones, So should I turn off qmwi it is on now.

 

[pronei]

If no MWI is used on QSIG links, remove from DCH programming. Remember after you remove, you will probably need to FDL the MSDL in LD 48.

 

[johnpoole]

yes, that may be what's causing the problem.

ld 96
dis msdl x all

enl msdl x fdl, writes the new config to the msdl.. always check to see what else that msdl is used for (map dch)

john poole
bellsouth business
columbia,sc

 

[grnichol]

I have found a new issue, The cisco system is sending me XXX-481-7789 on a outbound call to the pstn. The nortel is changing it to xxx-482-2345 (which is the main number here).
I not sure where it is inserting this number. Any help would be great.

 

[GHTROUT]

Is there Incoming Digit Conversion? IDC Tables on the route?

--
Nortel Resources at GHTROUT.com | Connect with me on LinkedIn
--