Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Nortel 81c Not able to suddenly get into ld 20

Status
Not open for further replies.

nortel23

Technical User
Jul 21, 2006
92
US
I have an 81c nortel switch and was building a phone in ld 20. As I was doing the print of the phone in load 20 the print suddenly stoped. After that I am not able to get to load 20. I do not get a REQ: prompt when entering load 20.
It says marp not active and I do not get any further. Any idea of what to do?
 
I am able to get into ld 32 and 22. I have tried ld 10,11 and 20. I get nothing after going to those ld's.
 
I had this same issue with an Option 11 and had to INI the switch to get it to work normally.
 
definately sounds like an ini is in order, unless a chg and limited access has been implemented behind his back.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top