I have a 5510 that has been working fine until I needed to unplug it and power it back on. Only the power light came on, so I plugged in a terminal and discovered that there was No Agent Code. I therefore connected the switch to another switch with a PC running TFTP. I set all the parameters for doing the load. The server was found and started sending the code and then I got a failure message that stated "My UDP port changed was=118D IS=0089. I also looked at the error log and saw a message of Bad port Mask = 00000000=LS; MS=00000000. I am stuck as to where to go from here.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Nortel 5510 No agent Code
- Thread starter lavrunin
- Start date
Similar threads
- Locked
- Question