Norstar T1 Caller ID Without PRI?

[wip]

Is it possible to have Caller ID information appear in the Norstar Business Series Terminals on a T1 system Norstar MICS 5.0 witha DTI Card without a PRI Enabler? The system is configures as a T1 from the LEC and has these parameters....B8ZS, ESF, WinkStart and they are LOOP Lines.

Does anybody have any suggestions that are right on in programming this KSU and software to perform Caller ID features using a T1 card and no PRI enabler? This is not a PRI circuit.....it is called Access Advantage and is put out by SWBELL and they seem to think other systems can do this, what about Norstar?

PLease provide programming changes if needed? such as needing Groundstart lines or Loop lines, and all signaling to make work if any suggestions.

Thank you all who will take the timeon this matter,

Joey D.
(WIP) - Work In Progress
Bgredhskr@aol.com

 

[mcrackin]

Yes it is possible to have DNIS along with ANI on T1 lines. This also depends on the carrier. The line have to be configured as E&M in order for this to happen. What will be displayed in just the number or also refered to as ANI. As long as the lines are DNIS and the Co provides this the it can happen.

Richard S McCranie
richm@comatrix.com