BlackCuervo
Technical User
Hi everybody
I am tryin' to connect a Router Cisco 2851 and a Norstar MICS 7.0. This is the scene: The Norstar MICS has a DTI card and a R2MFC card too, so its profile is the #2. Both cards are programmed as PRI. R2MFC provides 30 voice channels, DTI is supposed to provide 15 voice channels. R2MFC is connected to the CO directly and working fine. DTI is connected to the Router Cisco 2851. The Router Cisco 2851 has a VWIC G.703 module. I know that the module is programmed as a E1, without CRC4 and the switch type is set to Q.Sig. Do I need something more to ask to the Cisco programmer about the configuration? My problem is that when I dial the destination code designed to use the PRI-B (DTI's 15 Channels), I receive the message "No Free Lines" in the Norstar Telephones.
That's the problem!
Thanks in advance!
Rodrigo Estañol Corona
I am tryin' to connect a Router Cisco 2851 and a Norstar MICS 7.0. This is the scene: The Norstar MICS has a DTI card and a R2MFC card too, so its profile is the #2. Both cards are programmed as PRI. R2MFC provides 30 voice channels, DTI is supposed to provide 15 voice channels. R2MFC is connected to the CO directly and working fine. DTI is connected to the Router Cisco 2851. The Router Cisco 2851 has a VWIC G.703 module. I know that the module is programmed as a E1, without CRC4 and the switch type is set to Q.Sig. Do I need something more to ask to the Cisco programmer about the configuration? My problem is that when I dial the destination code designed to use the PRI-B (DTI's 15 Channels), I receive the message "No Free Lines" in the Norstar Telephones.
That's the problem!
Thanks in advance!
Rodrigo Estañol Corona