Norstar 6.0 (T1 tie lines) with Meridian Opt 61

[viper222]

I am trying to connect a Option 61 and a Norstar together with a T-1 inbetween as the tie lines. I have the DTI cards setup in both switches and if I have the OPT 61 setup an 2wire E&M Wink start incomming and outgoing and the Norstar setup for E&M Wink I can call the Opt 61 extensions from the Norstar but when I try to call the Norstar from the Opt61 I get a reorder tone. Anyone have two of these tied together so I could get a RDB and a Trunk TNB printout, or if anyone knows what I am doing wrong. Thank you.

 

[samh30]

To call directely from Op 61,you have to configure the tie lines on the MICS to be AUTO ANSWER,and you have to create a target lines with the received digits match the extension number for each set to be able to route the calls.I hope that helps. Good Luck!

http://www.samhassan.com

 

[janchundia]

viper222
Can you help me with your configuration for implementation in my office

Thanks.
Javier

 

[PERRYPJ]

ALSO CHANGE YOUR TYPE TO 4W E&M IN YOUR OPTION 61 NORSTAR T1 TIE ARE 4W

OLD ROLMEN WORKING ON NORTELS

 

[viper222]

Let me print out my configuration. I have this now working with the Norstar dialing 8+extension in the Option 61 and the Option 61 dialing 4 digits (Access code plus 3 digits of the Norstar. It was working with the full 24 channels but since then we have downgraded to the first 8 channels for voice and the other 16 channels for data by using a CSU/DSU to split the T-1. It will be a day or so but I will get you the Norstar Trunk config and the Option 61 RDB and TIE config.