Okay here is the pain in the butt question of the day.
I have a span that, if you trace, are connected together. First thought was that it was a trunk to trunk transfer, but on the other end the call does not appear. The other end only shows an active port, but no call on the line, as does this side. I disable one port, thinking that it would clear the other, but it did not. The other side stayed connected with a "HALFDISC" message on the trace. I am not sure what is happening. I have 12 ports that are doing this, so 6 pairs of connected trunks.
Does anyone have a clue? Is there a disconnect message that I am not getting on the line. This is not a PRI, but I feel I am having the same problem on PRI lines as well.
Any help with this would be greatly appreciated.
See other post to similar problem.
.trad 77 10
ACTIVE TN 077 10
ORIG 077 10 TIE RMBR 76 34
TERM 077 11 TIE RMBR 76 35
DIAL DN NONE
MAIN_PM ESTD
TALKSLOT ORIG 7 TERM 30
QUEU NONE
CALL ID 0 9997
PDCA 1 PAD 0 0 PCML MU MU
PDCA 1 PAD 0 0 PCML MU MU
I have a span that, if you trace, are connected together. First thought was that it was a trunk to trunk transfer, but on the other end the call does not appear. The other end only shows an active port, but no call on the line, as does this side. I disable one port, thinking that it would clear the other, but it did not. The other side stayed connected with a "HALFDISC" message on the trace. I am not sure what is happening. I have 12 ports that are doing this, so 6 pairs of connected trunks.
Does anyone have a clue? Is there a disconnect message that I am not getting on the line. This is not a PRI, but I feel I am having the same problem on PRI lines as well.
Any help with this would be greatly appreciated.
See other post to similar problem.
.trad 77 10
ACTIVE TN 077 10
ORIG 077 10 TIE RMBR 76 34
TERM 077 11 TIE RMBR 76 35
DIAL DN NONE
MAIN_PM ESTD
TALKSLOT ORIG 7 TERM 30
QUEU NONE
CALL ID 0 9997
PDCA 1 PAD 0 0 PCML MU MU
PDCA 1 PAD 0 0 PCML MU MU
