Noise Problem-AC1/AC2

[lapakhora]

Hi i have 02 PRI routes having access code 91 and 92, these are working OK. But when i define
AC1=91
AC2=92

and put both PRI route in RLI i get strange noise problem when i dial AC1 or AC2.
after dialing AC1 or AC2 i get a noise but this noise gets end when i finish dialing number and #.
When i revert back configuration and assigned 91 and 92 as direct access code of route then no noise heard.....
I cannot set DLTN=No as tone is required after dialing access code.

Can some body help how can i remove noise?
regards.

 

[GHTROUT]

Is the noise = dial tone sound? I think you can change the tone in the LD 56. I'm not certain what tone prompt that is. It might be ACNO

Find more at GHTROUT.com

 

[lapakhora]

Hi PAL, i am talking about the tone which we get after dialing AC1 or AC2...I et tone but with low noise, some times it is OK but most of the time i get noisy tone after dialing AC1 or AC2..
Can somebody help??
Regards