nodecond is successful but server not booting

[oraytektips]

hi,
I'm running nodecond on one of the nodes and the log output shows network boot successful but the server is not able to boot into diag mode.Please advice.Log output

Selected ethernet now active device
Nodecond Status: command is " ethernet,10,aui,half" encode-string " chosen-network-type" property
Nodecond Status: chosen network type set
Nodecond Status: command is " 000.000.000.000" " ibm,fw-clientipaddr" $setenv
Nodecond Status: client ip addr set
Nodecond Status: command is " 000.000.000.000" " ibm,fw-serveripaddr" $setenv
Nodecond Status: server ip addr set
Nodecond Status: command is " 000.000.000.000" " ibm,fw-gatewayipaddr" $setenv
Nodecond Status: gateway ip addr set
Nodecond Status: command is " 255.255.255.000" " ibm,fw-netmask" $setenv
Nodecond Status: netmask set
Nodecond Status: command is boot /pci@fef00000/ethernet@10
Nodecond Status: network boot successful
Nodecond Status: bootp sent over ethernet
Nodecond Status: waiting for "Please define the System Console" menu
Nodecond Status: will wait up to 792 seconds