No video at start up

[welcomewasteland]

My computer shows no video when turn on. I tried other graphics cards. Tried using other monitors. I installed a new mother board because there no bios loading screen comes up at all. One weird thing about it is that the monitor usually has a countdown from five to go into standby if there is no signal. When I turn the pc on it negates this countdown and goes into standby immediately. Could this be a hard drive issue? Any suggestions?

 

[Sleepsalot]

Do you hear any beep codes? If so what are they? If you have replaced the MBO you may have a bad processor.

Wayne

Life is a big Roleplaying adventure.

Wayne

 

[sonicalia]

Weird... I agree with Sleepsalot. Check for beep codes. Also make sure RAM is seated properly.

 

[Krosus]

Have you tried the monitor on another machine entirely or just swapped out components inside the PC case?, another thing is a lot of motherboards used to come with cmos clear jumper set to clear, try looking it up on the manual and making sure its set to the corrects pins.