I just had an SX200 ICP hard drive crash. Then found out my backup was no good. Starting over with all programming and have an issue with the AT&T PRI. Everything seems programmed properly and can call out fine, except no ring back. Call does ring called party but I hear nothing.
Also, can not get incoming to follow form 55. Set up trunks in form 15 with the x field set to 67 and have access code assigned to feature 67 in form 2. Calls only follow vacant DID location in form 19.
ANY help would be greatly appreciated.
Also, can not get incoming to follow form 55. Set up trunks in form 15 with the x field set to 67 and have access code assigned to feature 67 in form 2. Calls only follow vacant DID location in form 19.
ANY help would be greatly appreciated.