My Phaser 8400 has been in storage for a year. It had been connected to my G5 1.8 Power mac using OSX 10.3.9. I just connected it to my G4 1gig Powerbook running 10.4.9. while my G5 is being serviced. I attempted to install the OSX Driver dated 1/9/2004. For some reason the download would not open. I then downloaded the Cups driver update dated 2/6/07. That one did install OK. When I went to run some trial prints. there was no selection for image quality i.e. standard, enhanced, or photo from the drop down menu under "Copy & Pages" in the print window. I tried different selections in the "Print with Preview" window to no avail. Hmmm..... Is this an OSX thing. driver thing, Photoshop thing, or something else?
Your suggestions and comments would be greatly appreciated.
jerry
Your suggestions and comments would be greatly appreciated.
jerry
