I have a v3001 that i upgraded to 6.5.31 and enabled SIP mode on.
We are using NBX Native VM. We re-recorded all VM prompts and AA greetings.
AA's work properly, and normal VM operation works. The only time I seem to have an issue is on Xfer-to-VM directly. The caller does not hear anything... No audio at all. The VM port is in use, and releases just fine when they hang up. They just do not get any audio...
I do have 1 SIP trunk setup to a Conference Bridge (Using AskoziaPBX) and a dialplan entry in table 1 for 4640 to transfer to the Conference bridge.
We are using NBX Native VM. We re-recorded all VM prompts and AA greetings.
AA's work properly, and normal VM operation works. The only time I seem to have an issue is on Xfer-to-VM directly. The caller does not hear anything... No audio at all. The VM port is in use, and releases just fine when they hang up. They just do not get any audio...
I do have 1 SIP trunk setup to a Conference Bridge (Using AskoziaPBX) and a dialplan entry in table 1 for 4640 to transfer to the Conference bridge.